Help With Sheetmetal

[TomH33]

Hi
I am getting ready for my body install and have questions concerning the weather stripping and location(so the sheet metal seals to the body) of the striker covers and fuel tank side cover. This is pages 425-427 in my manual. Is anyone at the stage where you could post a picture or two the manual is so vague.

Does the striker cover go over or under the side sheetmetal and carpet. The position it shows in the manual would be under the side sheet metal. Which weather stripping do I use to seal to the body.

Any help would be appreciated.

Thanks TomH33

[TomH33]

Here is another item I am Not sure where it goes. Labeled 33481 & 33482 as cockpit rear lower corner L&R. 110747

Thanks TomH33

[TDSapp]

Here is another item I am Not sure where it goes. Labeled 33481 & 33482 as cockpit rear lower corner L&R. 110747

Thanks TomH33



Tom if you look at page 312 of the PDF manual (Version 2o) you will see where these go. In the picture of the manual they have red edges on them and they are at the very back pf the cockpit and on the side.


Tim

[FF33rod]

Tom if you look at page 312 of the PDF manual (Version 2o) you will see where these go. In the picture of the manual they have red edges on them and they are at the very back pf the cockpit and on the side.


Tim

As I near a similar point in my build I'm interested in these questions as well. Tim, pg 312 of my PDF manual (2V) is the emergency brake section. What section are you referring to and we can try to find it in the table of contents... Steve

[TDSapp]

It's the picture right above the EBrake handle assembly page.

Let me save you some time though...

http://hotrod.sapp-family.com/wp-content/uploads/2019/07/Sheetmetal.jpg

[FF33rod]

Ahhh gotcha, 309 in my version...

[TomH33]

Thanks

I got where the rear plates go. Any help on the striker plates or the weather stripping?

TomH33

[TDSapp]

Thanks

I got where the rear plates go. Any help on the striker plates or the weather stripping?

TomH33

Sorry, No help from me on that part... I have not gotten there yet, so when you get an answer, put it here so I will know when I get there. :-)