Autometer gauges-coyote motor-oil temp hook up

[magicmarto]

Hi Guys,
I'm running autometer gauges(amps, fuel, oil temp, oil pressure and water temp) and a 2017 coyote motor.
I have found where I hook up the oil pressure and water temp.
the coyote manual says nothing about where to hook up the oil temp.


Any input is appreciated

Thank you
Martin

[BEAR-AvHistory]

What oil pan do you have?

[magicmarto]

aluminum low profile moroso

I think I just figured it out. use the same sending unit as the one for the water temp
M

[Jeff Kleiner]

aluminum low profile moroso

I think I just figured it out. use the same sending unit as the one for the water temp

M

No, that would just give you two gauges reading the water temperature. Does your pan have an unused bung? If so that's where you would put the sender for oil temp. If you are using a remote filter the adapter will often have a port that will accept a sender, or if not it could be drilled and tapped for one.

Jeff

[BEAR-AvHistory]

aluminum low profile moroso

I think I just figured it out. use the same sending unit as the one for the water temp
M

MOROSO pans have multiple bungs use one of them for the oil temperature sender.

https://www.bimmerfest.com/forums/picture.php?albumid=9814&pictureid=48311

https://www.bimmerfest.com/forums/picture.php?albumid=9814&pictureid=48310

You many need an adapter to match the pans threads to the senders threads. Got mine at Home Depot. I just used the bung closest to the senders wire lead plug.

[magicmarto]

yup
Same pan as mine
Will do
Thanks guys
Martin