hard line to hose adaptor

[FF33rod]

The simplest things sometimes seem the hardest. I have 3/8" steel line for fuel. It has the standard inverted flare end with captive male fitting. I want to mate with a 3/8 i.d. hose so I've been looking for a female flare to hose barb adaptor. What would you use? Closest I've come is Parker 128HBLSV-6-6
http://ph.parker.com/us/27601/en/brass-hose-barb-fittings/128hblsv-6-6
What would you use?
Thanks for the help
Steve

[65 Cobra Dude]

Steve,

I would give Mark at Breeze Automotive a call. He has what you need and he is a vendor here.

Thx,

Henry

[WIS89]

Steve-

Henry's right, as usual!

Here's a link to what I think you want. Mark is a great guy to work with, has great products, and his service is second to none.

https://www.breezeautomotive.com/shop/fitting-3-8-od-tube-to-06an-male-316-stainless-steel/

I hope this helps.

Regards,

Steve

[FF33rod]

Thanks guys, that helps a bit. I wasn't planning on adapting to an AN fitting. Was just going to go from the 10u filter after the pump with a 3/8 hose and clamp both ends. In general, is there a "go to" vendor for all these fittings? I see a few on summit, a few on Amazon, Russell, .... doesn't seem to be one place to get everything.

[Mark Reynolds]

You could cut off the inverted flare end, install the 21608 and use this fitting in the end of the hose:
https://www.breezeautomotive.com/shop/hose-end-3-8-push-lock-to-06an-female/

[Babirusa1]

https://www.summitracing.com/search/part-type/fittings-and-adapters/fitting-category/an-to-hose-barb

[Babirusa1]

https://www.summitracing.com/parts/fra-484106-bl

[Babirusa1]

https://www.summitracing.com/parts/vpe-11207

[Babirusa1]

https://www.summitracing.com/search/product-line/edelmann-clamp-style-inverted-flare-to-hose-barb-fittings/part-type/fittings-and-adapters?fr=part-type&SortBy=Default&SortOrder=Ascending

[Babirusa1]

https://www.summitracing.com/parts/mor-65380

[Babirusa1]

Maybe one of the above will work