View Full Version : Tony Talked me into a Mark IV
Goldeneaglerv
12-05-2018, 05:41 PM
Well guys it was a quick decision after spending some time on the phone with Tony, A Mark IV is in my future... So the only problem I have is he stated that FF no longer makes headers for a 427… Not a stroker but a true FE block... Any thoughts where I can locate a set?
BadAsp427
12-05-2018, 05:51 PM
Start with Georgie at GAS-N
Goldeneaglerv
12-05-2018, 07:31 PM
Start with Georgie at GAS-N
Thnaks… Great Build Thread
Jeff Kleiner
12-06-2018, 06:11 AM
.. So the only problem I have is he stated that FF no longer makes headers for a 427…
FFR didn't make them anyway, Hooker did. You could check with them and see if they can dig out their jigs and make a set.
Jeff
frankb
12-06-2018, 08:29 AM
Goleneaglerev: Congrats on your decision! Have you pulled the trigger yet? Stainless Headers www.stainlessheaders.com manufactures custom headers if all else fails. If you are a handy guy with a welder, you can build your own. Not easy, but if I can do it, so can you!
98691 98692
Frank B
John4337
12-06-2018, 10:12 AM
Congratulations and enjoy the build, but if you think Tony talked you into something, wait until you see what the guys on this forum talk you into ;-)
John
Avalanche325
12-06-2018, 06:09 PM
Congrats!
Yeah, John is good at spending my money. Soft top, head rests........
Goldeneaglerv
12-06-2018, 10:32 PM
Thanks Guys getting excited looking at lots of great ideas from everyone's builds