Forte Clutch Canle Routing

[cv2065]

Hey all. For those that have the Forte Hydraulic clutch, what’s the best way to route the cable from the reservoir to the transmission? I was going to cut a hole in the inner driver’s side foot box with grommet but was curious how everyone else was doing it. Thanks.

[phileas_fogg]

That's exactly what I did. I secured the line to the 2"x2" frame at the top of the foot box, punched through the side panel, and then down to the slave cylinder. Be sure the line doesn't interfere with your mechanical throttle linkage if you have (or have plans for) one.


John

https://farm5.staticflickr.com/4297/36248672626_8ccd8147a2_z.jpg (https://flic.kr/p/XeaVuf)IMG_3502 (https://flic.kr/p/XeaVuf) by jhsitton (https://www.flickr.com/photos/91016165@N07/), on Flickr

[cv2065]

Thanks John. I had seen your picture before, but couldn't remember where I had seen it. I'm running the mechanical linkage as well.

[BadAsp427]

What, You dont want to have a stronger left leg..... I have the cable installed and it is a bit strong.... LOL.... you will know me when you see me, I'll be the guy with the Poppy The Sailor Man looking leg... I better start eating my spinach now...

[cv2065]

What, You dont want to have a stronger left leg..... I have the cable installed and it is a bit strong.... LOL.... you will know me when you see me, I'll be the guy with the Poppy The Sailor Man looking leg... I better start eating my spinach now...

LOL...I’ll limit my workout to 12 ounce curls...

[jrcuz]

I ran mine exactly like John with no problem.
JR