Roll Bar Drilling

[Fixit]

Doing some final work on the trunk area and I have a question.

(I'll be using the Tangent hidden upper mount - so I know not to drill the "outrigger" yet)

Which would be the best direction to drill the holes in the frame stubs & uprights?

Fore & Aft
or
Side to Side

[Papa]

I went fore and aft for mine; no particular logic applied.

[Jeff Kleiner]

I go fore & aft on the hoop and side to side at the bottom of the rear leg because that seems to make it a little easier to install & tighten the bolts---but I don't think it's real critical either way.

Jeff

[Fixit]

Thanks Guys...

I'm assuming the little weld blobs on the frame stubs are stops?

[65 Cobra Dude]

Yes,

That's correct John. the blobs are stops.

Thx,

Henry