vintage gauge power

[davespencer]

hello all- just looking for any advice/recommendations to power the voltage gauge. mk iv complete kit with ff vintage gauges the sheet from the manufacturer just says attach yellow line to "12 volt power source". not sure where to hook up to.
thanks for any/all responses
dave s

[edwardb]

It draws very little current. You could pretty much pick any ignition switched circuit. Personally, I use the Brn Gauge Feed wire, same as powers all gauges, since that wire is already in the dash harness. Or you could pull from another source like radio, choke, wiper, heater.

[davespencer]

thanks much edward i will give that a try
truly appreciate the help
if you ever decide to drive one of your creations up to traverse city let me know would love to see it

[GFX2043mtu]

My Ron Francis harness had a plug and play voltage connector for the voltage gauge sensor line.

[edwardb]

If you ever decide to drive one of your creations up to traverse city let me know would love to see it.

Don't typically make it that far north. But I would love to. Beautiful part of the state and lots of great cruising. We'll see. Some invitation stands here. If you're in the SE area, give me a shout. I enjoy having visitors.


My Ron Francis harness had a plug and play voltage connector for the voltage gauge sensor line.

You're right. Need to remember to check the newest version schematic since it looks like everyone is receiving that one now. The connector is on the Brn Gauge Feed wire I recommended in the previous post.