Overflow Tank Brackets?

[Tex2131]

FF sent this tank and brackets with my complete roadster kit. The holes to mount the bracket to the frame are about four inches apart. If I were to try to mount it per the manual to the 3/4 tubes it would sit at about a 20 degree angle. If I set it vertically the bracket holes don't line up with the 3/4 tube.

If I try to mount it directly to the F panel the tank won't let it fit flush. I called factory five and was told I would have to fabricate something to install where the manual says it should go.

This is the first time FF has disappointed me with a lack of service. Not happy.

The only place in the engine compartment this thing will fit vertically is on the X frame.

Looks like I'll be shopping for something that fits.

Any ideas would be appreciated.

[boat737]

I made a bracket that attaches to the upper and lower 3/4 inch tubes, and to the F-panel. I used the bigger Summit tank and wanted it as secure as possible. Seems to be perfect. And your right, the angles are a problem, just had to do some fitting and bending to make it fit flush everywhere.

[GFX2043mtu]

Before you mount it make sure the volume of the tank will be enough for your motor. I had to go with a Moroso one because the FFR tank was to small.

[Tex2131]

Before you mount it make sure the volume of the tank will be enough for your motor. I had to go with a Moroso one because the FFR tank was to small.
Good advice, thanks Don.