View Full Version : Upgrading to a 427W...have some 302 parts for sale
Joe Campbell
04-07-2018, 02:36 PM
I've stepped up to a 351-based motor, so I have these available from the 302:
Kevko cobra kit car oil pan (single rear sump, 7.5in deep) and matching pickup, $200 shipped.
Headers made by Stainless Headers, mild steel, ceramic coating, 3-in. header bolt spacing for aftermarket heads (no dimples in the tubes and easier to access. A little bit of oil got on one from a leaky valve cover, but can probably be buffed) One bung on each side for EFI. $400 shipped.
302 Edelbrock Performer RPM Air Gap intake, $230 shipped.
8378883787
Joe Campbell
06-30-2018, 02:11 AM
Updated.
FFRSpec72
07-14-2018, 12:11 AM
Joe, I have World 200 Heads, would these fit? as I'm trying to get rid of the J-Pipes.
Joe Campbell
07-16-2018, 12:33 AM
Sorry I missed your message the other day, been trying to get the new motor going.
If your heads have the dual bolt holes on each exhaust port, yes, they'll fit. I had them made to use the outer 3" spacing. Easier bolt access and don't have to pinch off the tubes for bolts on the inner spacing.
Shady302
07-20-2018, 03:58 PM
Pm sent on kevko oil pan. Thanks.
Joe Campbell
07-27-2018, 12:50 PM
PmD you back
Joe Campbell
10-20-2018, 11:33 PM
Updated.
Couple of questions on the headers. What size are the tubes? They look like 1 3/4. I assume these are not stainless steel, correct? What heads were you running? Raised exhaust ports are standard? I'm currently running the FFR BBK headers and don't want to get into major alignment issues. My heads have the dual bolt pattern so going to a larger pipe diameter intrigues me.
Bob
Joe Campbell
11-01-2018, 10:14 PM
Sorry for the delay, been crazy at work lately. They are 1-3/4 tubes, carbon w/ ceramic coating. I was running RHS 200CC heads, 64cc chambers - standard height exhaust ports. Was just shy of 10:1 compression so I'm sure I was leaving power on the table.
Joe Campbell
11-13-2018, 08:28 AM
Also, open to partial or whole trades, looking for FFR manual rack, EPS parts, manual rack adapter.
R. Button
11-14-2018, 10:35 PM
Joe,
Do you still have the
MSD 8582 two-wire dizzy?
I have a new manual rack that I picked up with a lot of other parts from someone. Interested in a trade?
Joe Campbell
12-08-2018, 12:25 PM
Updated prices and items. Thanks for the trade Ralph!