View Full Version : Factory Five Inertia Switch
bcsellie
03-28-2018, 06:10 PM
My inertia switch in my new build is not working. Pumps work if I bridge the wires. Anyone have one they aren't using?
Blaine
michael everson
03-29-2018, 05:14 AM
Make sure the wires are plugged into the correct connections in the connector. I think there are 3 slots. Only 2 are used. If that doesn't fix it, I can send you one. PM me
Mike
bcsellie
03-30-2018, 10:08 AM
Make sure the wires are plugged into the correct connections in the connector. I think there are 3 slots. Only 2 are used. If that doesn't fix it, I can send you one. PM me
Mike
PM sent
Did you engage the switch? It comes unset and you need to press the button to fully depress the plunger and engage the switch. You can check for continuity across the terminals with an Ohm meter. If you have continuity across the switch, then you likely have a bad chassis ground.
Dave
japollon
03-30-2018, 11:57 AM
With the inertia switch engaged, you should have continuity across the terminals? Yes?
With the inertia switch engaged, you should have continuity across the terminals? Yes?
Correct!