Motor lift point and bell housing bolt sizes?

[Svtfreak]

Anyone recall off the top of their head? I think I measured them to be m14x2.0x40mm for the lift bracket holes and M10x1.5x ~80mm for bell housing bolts for automatic. And what thread is converter studs? Wait, that may not matter though as I have 6r80 and I think most of you guys have the 4r70. Ok, tread pitch would be useful to make sure I’m right.

Thanks guys.

[SelectivePC]

Thread pitch and length for a 6R80 bell housing and engine lift points is correct, thread size and pitch on the converter Im not 100% on as we dont have a stock converter here for some reason. haha.

[Svtfreak]

Thread pitch and length for a 6R80 bell housing and engine lift points is correct, thread size and pitch on the converter Im not 100% on as we dont have a stock converter here for some reason. haha.

Thanks! I got all my bolts now. 46$ worth! I can’t beleibe they didn’t come with it actually, the bell housing bolts at least.

The converter studs are M10x1.0 for future reference.

[SelectivePC]

Thanks! I got all my bolts now. 46$ worth! I can’t beleibe they didn’t come with it actually, the bell housing bolts at least.

The converter studs are M10x1.0 for future reference.

I wanted to say that, but like I said didn't have one to check. Glad you got it all figured out.

Did you buy actually lifting hooks for a Coyote? That didnt come with bolts?

[Svtfreak]

I did not buy the hooks. I’ve got some plate steel and gonna cut out my own.