Stripes

[wjsunderhill]

Where do I find the information on the stripe width and location?

[NHolds]

See Below

[LewPoberezny]

2621 This is what I used

http://www.erareplicas.com/427man/stripes/stripes.pdf

[Gumball]

... and the database here continues to build - thanks, Lew!!!

[CapeCoralCobra]

I used this one. With a 1" center gap, the extra 3/4" width at the front end allows the stripes to continue just outside the oil cooler opening, instead of ending at the opening and restarting underneath:

http://www.bairds.ca/FFR/images/ffcobra/11446stripepattern.jpg

2622 2623

[weendoggy]

I used this one. With a 1" center gap, the extra 3/4" width at the front end allows the stripes to continue just outside the oil cooler opening, instead of ending at the opening and restarting underneath:

http://www.bairds.ca/FFR/images/ffcobra/11446stripepattern.jpg

2622 2623

The problem with keeping the width the same all the way is the optical allusion that they are wider at the nose as seen in your picture. jmo

[wjsunderhill]

Thanks for the help. Bill

[weendoggy]

I used this one. With a 1" center gap, the extra 3/4" width at the front end allows the stripes to continue just outside the oil cooler opening, instead of ending at the opening and restarting underneath:

http://www.bairds.ca/FFR/images/ffcobra/11446stripepattern.jpg

2622 2623

Keeping them semetrical all the way gives the look of a wider stripe in the front. Just something to consider. Yoiu can always adjust the stripe all the way when using the pin stripe. I did that on a car and it turned out fine.