Could someone identify these parts for me please?

[wareaglescott]

Getting all my panels ready for the powder coater. Could someone please identify these for me so I can determine where they go?
Thank for the help!
http://thefactoryfiveforum.com/attachment.php?attachmentid=55920&d=1468111514

[rich grsc]

Not sure about the small one, but the other two are a throwback to a donor build when you used the Fox body switches.

[wareaglescott]

Thanks Rich. I am doing a non donor build. So I assume I can discard them?

[65 Cobra Dude]

I still use them to stiffen the dash.

Henry

[DaleG]

yes, good for stiffening the dash: locate them out of the way of anything else. drill/tap/screw the short side to the 2x2 under the dash; the log end fits above the lower dash lip; drill/screw it to the lip. Unless, of course you are going to go with a length-wise under-dash filler panel.

[edwardb]

The small piece is the filler for where the PS fuel tank strap goes through trunk floor. All the way at the back. You'll need that one.

[Mesa Mike]

Instead of using the two pieces to stiffen the dash get a piece of alumin. longer to stiffen the dash. I used about a 18" piece and put my heater knobs, 12v cig. outlet to
charge mobile phone and a couple more switches there that I wanted not on the dash.

[wareaglescott]

Instead of using the two pieces to stiffen the dash get a piece of alumin. longer to stiffen the dash. I used about a 18" piece and put my heater knobs, 12v cig. outlet to
charge mobile phone and a couple more switches there that I wanted not on the dash.

Do you have a picture of this set up?

[Norm B]

I did something similar to Mesa Mike. I made three panels. The centre one has a hinged opening in it for a small amp and has the cigarette lighter plug and stereo jack. Here is a picture. You can see the courtesy lights and the clock adjust button on the passenger side.

HTH

Norm

[wareaglescott]

Thanks for pic Norm B!

[Mesa Mike]

Yep, mine looks a lot like Norm's.