Pin Drive IFS Bracket Question

[Jim Doak]

My FFR-supplied pin drive IFS brackets each have four mounting holes. I'm guessing one set for Fox spindles and one set for SN95 spindles?

I have '97 SN95 spindles and I'm guessing that I use the lower-most hole and its corresponding second from top hole. It that correct?

[rich grsc]

http://www.factoryfiveparts.com/pin-drive-width-spindle-adapter-bracket/

[Jeff Kleiner]

Pin drive adapters only have 2 holes, not 4.

Jeff

[Jim Doak]

Factory Five needs to update the photo on their web site because it's confusing to guys like me. The IFS brackets I received a couple of weeks ago had "12507" written on them which is the part number for pin drive IFS brackets. They're also dimensionally different than the old IFS brackets I had on my SN95 spindles. And they have two sets of holes, not one set as show on the link posted above.

Check out post #13 here from Jim Schenck:

http://thefactoryfiveforum.com/showthread.php?15369-Front-Pin-Drive-to-wide

I'll call Factory Five tomorrow and confirm which set of holes to use. (I'm pretty sure that I'll end up using the lowest hole and its corresponding mate.)

[Hotyacht]

I had the same confusion when I received the brackets for my pin-drive IFS parts and queried them with FFR.

They have changed the parts and now have just one universal bracket that fits all.

Picture of the brackets and spindles as I received them plus the diagram sent by FFR showing which holes to use.

528835288452885