karlos
03-26-2016, 10:56 AM
A couple questions on the rear harness. The picture below is from Edwardb's 7750 build thread.
1. I want to go ahead and put the connectors on the vehicle-side harness. It looks like from the photo that the harness extends about 3 or 4 inches beyond the sheetmetal. Is that about right? I could test fit the body but it's far easier to ask instead :)
2. What's the thinking on the extra ground? Is it just a case of 'you can never have too many', or is it there to address a specific problem? I assume the ground wire that runs back through the main harness is still being used, and that the extra ground is simply an extra piece of wire that's been spliced in and attached to the chassis. Do I have that right?
http://thefactoryfiveforum.com/attachment.php?attachmentid=52047&d=1459007095
1. I want to go ahead and put the connectors on the vehicle-side harness. It looks like from the photo that the harness extends about 3 or 4 inches beyond the sheetmetal. Is that about right? I could test fit the body but it's far easier to ask instead :)
2. What's the thinking on the extra ground? Is it just a case of 'you can never have too many', or is it there to address a specific problem? I assume the ground wire that runs back through the main harness is still being used, and that the extra ground is simply an extra piece of wire that's been spliced in and attached to the chassis. Do I have that right?
http://thefactoryfiveforum.com/attachment.php?attachmentid=52047&d=1459007095