Center console and dash connection panel

[metros]

Does anyone know dimensions of the below panel that connects the center console to the dash? The panel that this builder has mounted his head unit in. I have a fiberglass version of this panel and thought that FFR started producing these in aluminum but have been told that FFR did not make that panel.

I found that picture on Google and don't know who the builder is.

Thanks!

[metros]

http://i100.photobucket.com/albums/m35/mxmetros6/818%20Build%20Album/center%20console%20front_zpszf2kckyn.jpg

[Hindsight]

Pretty sure that's Rori.... I can tell by the spotless garage floor and lack of clutter lol

I plan on making mine out of aluminum... same rough sizing. Make it of cardboard and tape first then transfer to aluminum sheet.

[THE FURNACE]

Definitely Rori. I just read his build thread last week. As spotless as the McLaren factory, and cleaner than a lot of hospital rooms. Has anyone read that article in PM mag?

[RM1SepEx]

Does anyone know dimensions of the below panel that connects the center console to the dash? The panel that this builder has mounted his head unit in. I have a fiberglass version of this panel and thought that FFR started producing these in aluminum but have been told that FFR did not make that panel.

I found that picture on Google and don't know who the builder is.

Thanks!

Note that his is NOT the FFR aluminum setup, its custom, their setup is a basic rectangle in aluminum, same width as the tunnel, about 5 1/2 inches wide