Racee75
11-29-2015, 06:50 PM
Hi Everyone,
Looking for some quick advice. After several months of my kit sitting in the garage I have finally started to assemble. I see in the manual that there is a need to use the 5/8" washers to take up the extra space that is allowed for the stock Mustang control arms. I have found that the front mount on the passenger side has a 1/8" gap as well.
Is this just due to weld pull and has anyone had an issue with pulling this in when tightening ? Or has anyone needed to use washers on the front mount as well ?
Thanks in advance
Looking for some quick advice. After several months of my kit sitting in the garage I have finally started to assemble. I see in the manual that there is a need to use the 5/8" washers to take up the extra space that is allowed for the stock Mustang control arms. I have found that the front mount on the passenger side has a 1/8" gap as well.
Is this just due to weld pull and has anyone had an issue with pulling this in when tightening ? Or has anyone needed to use washers on the front mount as well ?
Thanks in advance