Tangentkits
10-29-2015, 03:38 PM
I just wanted to post up some pictures of a project I did recently for car show art/photo album podiums. I just got these back from the powdercoater late yesterday so I haven't gotten a chance to get any good pictures of them in front of nice cars yet.
The idea is that you can drive your car to a show, quickly set this stand up and pull your front tire onto the base to lock it sturdy. and the support struts running the length of the base make the entire upright assembly very sturdy. Then you can set your cars build photo album or framed dyno sheet or Magazine article onto the stand to tell the "whole story" of your cars build while you walk the show. They are designed as 3 main parts that can quickly be taken down to pack up into a small roadster trunk.
I figure up these will be right around $200 powdercoated silver vein as pictured and depending on interest I may offer them raw so buyers can paint them to match their car.
46990469894699146992
These are the first run and I'm going to start on the second run next week. Shoot me a PM here or an email if you'd like one.
Best regards,
Eric Schloesser
Tangentkits@outlook.com
Web: http://tangentkits.com/
Facebook: https://www.facebook.com/tangentkits
The idea is that you can drive your car to a show, quickly set this stand up and pull your front tire onto the base to lock it sturdy. and the support struts running the length of the base make the entire upright assembly very sturdy. Then you can set your cars build photo album or framed dyno sheet or Magazine article onto the stand to tell the "whole story" of your cars build while you walk the show. They are designed as 3 main parts that can quickly be taken down to pack up into a small roadster trunk.
I figure up these will be right around $200 powdercoated silver vein as pictured and depending on interest I may offer them raw so buyers can paint them to match their car.
46990469894699146992
These are the first run and I'm going to start on the second run next week. Shoot me a PM here or an email if you'd like one.
Best regards,
Eric Schloesser
Tangentkits@outlook.com
Web: http://tangentkits.com/
Facebook: https://www.facebook.com/tangentkits