Frank818
08-23-2015, 08:06 PM
I must admit thinking out of the box on my build causes a HUGE load of decisions to take down the road. I always have many questions I usually find answers for by myself or the forum (tnx to so many of you!!!!!), but we haven't seen many pictures of the humps deck lid close enough for me to guess on one critical measure.
It's actually a very important one for me as I have to decide between 3 costly options:
- Buying a potentially lower 830 bucks billet cam cover (see below);
- Doing some kind of fiberglass body work myself which will certainly end up very bad and cost me a lot anyway;
- Paying many 100s someone to do the body work for me.
The VR6 is high compared to the WRX, of course, and I am looking at the precise clearance I am allowed at the top. I know the humps panel has a 2 or 2-1/4 clearance by itself at the front between the humps and over the top 1.5" square tube, but once that panel is installed, is it installed at the same level as the top of the 1.5 tube or higher?
On the below picture, how high over the 1.5 tube sits the red line? That's the right question.
44689
Billet cam cover
44690
tnx in advance!
It's actually a very important one for me as I have to decide between 3 costly options:
- Buying a potentially lower 830 bucks billet cam cover (see below);
- Doing some kind of fiberglass body work myself which will certainly end up very bad and cost me a lot anyway;
- Paying many 100s someone to do the body work for me.
The VR6 is high compared to the WRX, of course, and I am looking at the precise clearance I am allowed at the top. I know the humps panel has a 2 or 2-1/4 clearance by itself at the front between the humps and over the top 1.5" square tube, but once that panel is installed, is it installed at the same level as the top of the 1.5 tube or higher?
On the below picture, how high over the 1.5 tube sits the red line? That's the right question.
44689
Billet cam cover
44690
tnx in advance!