ckrueger
08-04-2015, 08:09 PM
I put this up on the other forum and thought I would throw it out here too.
"I received the pins from Ford Racing and got the PCM wired up with the two new wires. Getting ready for the connections to the speed dial and have a couple of connections. The Ron Francis harness plug to the output at the transmission has two wires. One grey and one green. According to the wiring diagram I have it looks like the grey one is the output and would be the one to tie into the green wire from the speed dial?? This also looks like this would be the one to tie into the white wire on the Speedhut speedo I am using. (Speedhut Vintage gauges).
What does the other wire of the sensor connect to?
The Speedhut Speedo has two connections. One white and one black. It says to tie the white to the sensor output and the black is optional if the sensor has a ground. Does the black need to be hooked to a ground with the Tremec sensor?
As I have said before, the wiring is not my sweet spot. any help would be appreciated."
"I received the pins from Ford Racing and got the PCM wired up with the two new wires. Getting ready for the connections to the speed dial and have a couple of connections. The Ron Francis harness plug to the output at the transmission has two wires. One grey and one green. According to the wiring diagram I have it looks like the grey one is the output and would be the one to tie into the green wire from the speed dial?? This also looks like this would be the one to tie into the white wire on the Speedhut speedo I am using. (Speedhut Vintage gauges).
What does the other wire of the sensor connect to?
The Speedhut Speedo has two connections. One white and one black. It says to tie the white to the sensor output and the black is optional if the sensor has a ground. Does the black need to be hooked to a ground with the Tremec sensor?
As I have said before, the wiring is not my sweet spot. any help would be appreciated."