gauge cluster issue

[Lumpyguy]

Ok so I have my 818 up and running, I It looks like everything is working on the gauge cluster and the lights too. I had my gauge cluster taken apart and removed a few LEDs and put in a new programed chip for the Odometer zeroing. I had all zeros on all the Odometer and ran the wheels on the jack stands and put on .2km on the trip ODO and when the ignition was turned off and then back on the ODO was back to Zero?

Anyone had or seen this issue?

[Bob_n_Cincy]

Ok so I have my 818 up and running, I It looks like everything is working on the gauge cluster and the lights too. I had my gauge cluster taken apart and removed a few LEDs and put in a new programed chip for the Odometer zeroing. I had all zeros on all the Odometer and ran the wheels on the jack stands and put on .2km on the trip ODO and when the ignition was turned off and then back on the ODO was back to Zero?

Anyone had or seen this issue?

I know the trip odometer resets if you disconnect the battery in the car.
1. You did this
2 you don't have the always hot battery connection to the dash. My car is connector B pin 8 on the gauge pod
Bob

[K3LAG]

I know the trip odometer resets if you disconnect the battery in the car.
1. You did this
2 you don't have the always hot battery connection to the dash. My car is connector B pin 8 on the gauge pod
Bob

This is correct. The trip odometer resets when you remove power. The regular odometer does not, but yours probably still reads zero since you have only gone .2km and it only displays whole numbers.

Larry