Modification for passenger side coolant lines

[Pearldrummer7]

So I ran both of my coolant lines down the passenger side, and ran a clearance issue with my rear fender/side body piece. This is what I did as a solution, since I couldn't really get the lines lower/closer together.

https://c1.staticflickr.com/1/338/19255928292_fb52c14a46_z.jpg (https://flic.kr/p/vkzEBE)

I figured this would work since I don't have doors that will open. I'm going to put some of this (http://www.mcmaster.com/#catalog/121/3838/=xtzfpf)on the edge with the coolant pipe. It forms to surfaces really nicely. Wish I knew about this stuff before I started the build! I can post more detailed pictures of the cutaway if anyone is curious. I plan to do the reverse notch on the door piece for this side.

Any one else have a different solution for this?

[Evan78]

Just curious - why did you put both lines on the passenger side?

[Pearldrummer7]

Evan,

I did this for ballast. I know one of the cars FFR built did the same, and I believe some other members have done it as well.

Here's a pic of what it looked like without body panels.
https://c4.staticflickr.com/8/7761/17792513870_7110e7a483_z.jpg (https://flic.kr/p/t7ghuw)

[Evan78]

Ah, that makes sense. Thanks.