Seat choice

[Warden]

I have read several threads about seats and I know there are several aftermarket and donor seats that can be "made" to fit the 33. My build will be close to stock with very few modifications due to my skill level but I need all the legroom I can get and would also like a little more back and shoulder support compared to the stock FFR seats. If any of you guys that have already built or are building could look at this seat and give me your thoughts I would be thankful! I haven't ordered yet so I can't do my own measurements. Thanks!

Procar Evolution

[maczter]

I have the exact same seat. It fits but hits the tranny tunnel and side, so adjusting it is not in the cards but it beats the heck out of the stock seat and I like the looks.

[Warden]

Thanks for the reply! Is it the seat frame that touches or just the cushion part? Could you send a picture of the seats showing the height of the installed seat back. Thanks!

[ehansen007]

Thanks for the reply! Is it the seat frame that touches or just the cushion part? Could you send a picture of the seats showing the height of the installed seat back. Thanks!

I would consider the big and tall seats that FFR now makes and put in the double hoop roll bar and add a headrest on the roll bar. Definitely a more versatile option and allows you to retain that hot rod look. Otherwise you're modifying the tranny tunnel or paying $1200 as seat for something exotic like a tillet or Sparco that are hard to get in and out of and a lot less comfy. I did so much research on this it was crazy. Hope this helps.