View Full Version : windshield problem
I am at the point where I am trying to solve the windshield spacer stacks however today when I took the uprights out of the box I noticed that there are no holes to mount them to the car is there a template or drawing of where these holes are to be drilled
michael everson
05-03-2015, 04:34 PM
This is usually done by dropping the windshield into the slots and down on the body. You will have to cut the length in order to get them all the way down. Then mark through the frame where the holes will be drilled. Then just center the holes on the width of the arms before drilling. Measure from the rear corner of the body at the door opening to the top screw of the windshield side post. This should measure 27 inches.
Mike
Thanks Mike I thought that by now there would have been a hole template But I guess I will have to put the body on just to get this measurement. What a pain I am getting between my ears