View Full Version : Aluminator XS dyno pull
rcotner
01-20-2015, 08:10 PM
https://www.youtube.com/watch?v=juz6...ature=youtu.be
rcotner
01-20-2015, 08:21 PM
Try this one if the first one doesnt work...
https://www.youtube.com/watch?v=juz6DuZzJDk&feature=youtu.be
2bking
01-20-2015, 08:44 PM
So, what are the numbers?
I like the red frame.
rcotner
01-20-2015, 11:18 PM
406 rwhp, 375 ftlb at 6500 RPM. Redline it at 8000 rpm. There is a bit more tuning to to. I am hoping for 420 whp which would put it close to the spec for this engine.
rcotner
01-21-2015, 11:33 PM
Final pull results 425 wHP. I am happy!
37919
wallace18
01-22-2015, 08:29 AM
Very impressive! It will be hard to keep tread on the rear tires. LOL.
3dGuy
02-19-2015, 03:55 PM
Have you done any modifications to the chassis or your build to take the power from that engine or to get it to fit?
rcotner
02-19-2015, 04:55 PM
The only mod required to get a coyote to fit is relocation of the alternator and subsequent removal of one of the stock alternator mounts. The aluminator XS is a very tall motor due to the large intake plenum and throttle body so a bubble hood is required. The intake I am using make hood and side covers difficult. I had to shorten the drive shaft about 0.75" to fit with my T56 transmission. Pretty simple stuff in the big picture.