Anyone know the pin out for Denso 36010FE020 Throttle Pedal Assembly?

[ninjanick]

I'm assuming the DBW pedal outputs 0-5VDC when powered by 12VDC bus, but I don't have the associated pin out. Pedal should be from an 06 WRX. I read a post on NASIOC stating the following pin out:

6 - Sensor
5 - GND
4 - PWR

I tried this, but the senor lead (referenced to GND) didn't move when the pedal was depressed.

[Bob_n_Cincy]

I'm assuming the DBW pedal outputs 0-5VDC when powered by 12VDC bus, but I don't have the associated pin out. Pedal should be from an 06 WRX. I read a post on NASIOC stating the following pin out:

6 - Sensor
5 - GND
4 - PWR

I tried this, but the senor lead (referenced to GND) didn't move when the pedal was depressed.

Here is the schematic of the 06 wrx pedal.

36055

[ninjanick]

Thanks Bob_n_Cincy! You wouldn't happen to know the signal names of each connection? From looking at the schematic pin 2 is GND. I am interested in knowing if the pedal has a 0-5VDC out for an EV conversion.

[Bob_n_Cincy]

Thanks Bob_n_Cincy! You wouldn't happen to know the signal names of each connection? From looking at the schematic pin 2 is GND. I am interested in knowing if the pedal has a 0-5VDC out for an EV conversion.

On the 06 wrx pedal:
Pin 1 red/blue is +5v power from the ecu internal power supply ecu B22.
pin 2 red/green is sensor ground b30
pin 3 blue APS signal 2 ecu b31
pin 4 light green APS +5v ecu b21
pin 5 yellow APS Ground ecu b29
pin 6 red APS signal 1 b23

Pin 1,2 & 3 is one potentiometer and pins 4,5 & 6 is a second potentiometer.

http://thefactoryfiveforum.com/attachment.php?attachmentid=36096&d=1417274976

[ninjanick]

Thanks for the info!