Turn Signal Wiring

[RdstrRod]

I have the Ron Francis Wiring Harness that came with my complete kit. I also have Russ Thompson's Turn Signal System, and an extra Green T/S Indicator Light. I would like to use the Push Button on the end of the T/S Stalk for the Horn. That appears relatively easy to wire. However, I would also like to keep/utilize the 2 Toggle Switches for the Hazard & Hi/Low Beam Lights. Is there a simple way to wire Russ's System into the harness to make it all work? In other words, do I still need those extra Diodes & Relays, or is there a way to make this easier?
Thanks in advance, Rod

[pc12cvs]

Rod,

I used the same setup (RF Harness, RT turn signal). The RF harness has all the components needed to make it work (without buying the extra diodes and relays mentioned in the RT directions). Been a few months since I wired that part, but I remeber it being almost exactly the same as the wiring diagram showed in the RF manual, except substituting in the turn signal wires from the RT system. Plugged all my external lights in a few days ago and verified they work correctly (turn signals flash, high/low beam, brake lights, etc.), no extra components bought......always kind of surprised when my wiring works since I have very little experience with it.

I also wired the stalk button as a push to pass momentary switch along with a high beam 2-position switch on the dash. There's that option too.

Hope that helps,
Noel

[RdstrRod]

OK Noel, thanks for the reply. "Someone's done it". That's the answer I was looking for. I'll give it a try.

Rod