Reverse Lights/Rear Turn signal wiring help

[Jay18g]

Hey Guys,
Can someone explain to me how to wire in the 2 pole flasher into the small rear taillights. This is how I currently have it hooked up with no luck :-/...

12V ---> X Terminal on Flasher
Reverse Lights_12V ----> Bulb terminal
Turn Signal_12V -----> L Terminal on Flasher & Bulb Terminal
Flasher Gnd-----> Chasis Gnd

Please correct my mistakes. Thank you

Jason

[Jaime]

The turn signal wiring goes through the hazard switch. Basic flow diagram is this:



12V Battery ---------------| |---- Right Blinker Switch ---- Right Blinker Bulbs ---- Ground
| |---Hazard Switch -----------|
Hazard Switch ---------- Turn Signal Module -------|
| |---Hazard Switch -----------|
12V Ignition Switched -----| |---- Left Blinker Switch ----- Left Blinker Bulbs ----- Ground

The hazard switch has three parts:

A switch that switches the circuit to be powered by battery when the hazard switch is pushed and powered by ignition when it's not.
A switch that activates the left blinker
A switch that activates the right blinker

You have the ground on the flasher module correct, but the other two should both go to the hazard switch.

[Jay18g]

Thanks for the reply. The thing that I'm most confused about is how this 2 pin bulb is going to serve a dual purpose as reverse lights and blinkers. Ex. There are 3 signals. Blinker, reverse, and ground but only two pins on the bulb. Any further help would be appreciated.
Thank you
Jason

[Jay18g]

Disregard this post. Realized the lights come with the wrong bulbs installed. Got it working now haha