Part Identification Help

[Jaime]

I could use a bit of help identifying parts in box 4. Here's all of the laser cut parts from the box:

http://i871.photobucket.com/albums/ab273/jaime398/818%20Build/Box4Parts_zps3585f7ae.jpg

The packing list had these items that I think are laser cut:


80558 REAR HATCH HINGE, LH ------------- 1
80559 REAR HATCH HINGE, RH ------------- 2
10961 RIVNUT TOOL / COIL-OVER WRENCH --- 8
80556 HEADLIGHT MOUNT BRACKET (2) ------ ?
80508 SIDE MIRROR MOUNT (2) ------------ 3 and 4
14097 LICENSE PLATE BRACKET ------------ 7
80534 RADIATOR TOP MOUNT, LH ----------- ?
80535 RADIATOR TOP MOUNT, RH ----------- ?
80590 NOSE MOUNT, LEFT ----------------- ?
80591 NOSE MOUNT, RIGHT ---------------- ?


Thanks in advance.

[wleehendrick]

5, 6 are the headlight mounts
9,10 are the nose mounts

[Jaime]

Thank you. So, it's the radiator mounts that I need.

I'm very pleased with the small number of backordered parts. Just headlights, sway bar threaded rods, brake lines, and radiator mounts. I was also missing one of the four seat mounts, but I want to get my factory seats installed with the sliders, so I wasn't going to use them anyways.

[Mechie3]

They're shipping radiator mounts now or are these the long pieces that hold the front subframe at the top?

[Jaime]

Those connect the hatch to the hinges. My packing list said the radiator mounts are in box 9, but they aren't. That means one of two things; either it was a mistake and the mounts are still not available, or it was a packing error and the mounts are available, but didn't make it into my box 9.

[wleehendrick]

I thought the radiator mounts were the long perforated pueces Craig mentioned. Unless things have changed, you reuse the donors mounts (or buy Craigs)

[wleehendrick]

Just send Joe @FFR the pic and he'll tell you what youre missing, and get it shipped.

[Jaime]

Ahhh... the light bulb is now on. I didn't expect those to be called "RADIATOR TOP MOUNT". I already got those back from powder.

http://i871.photobucket.com/albums/ab273/jaime398/818%20Build/20140514_183021_zpsvmuwf4s3.jpg

[metalmaker12]

Make your own brake lines out of nickel copper line. It flexes easy and flaires nicely, plus never corrodes. It comes in roles and straight runs. If I had to do it again that's what I would do.

[Mechie3]

If I had to do it again I'd buy the freakin Eastwood Brake Tool for $200.

[Evan78]

5 and 6 are headlight brackets.

[Doowop]

Mechie, I just bought the Eastwood tool!! ahah, thinking ahead!

So all the metal parts just come raw metal?

[RM1SepEx]

tons of raw metal... I PCed everything with a cheap kit from Eastwood and an old oven that the older woman was "very happy to see someone would use it" it had a bad burner... who cares!