required or recommended frame mods before powder coating

[nkw8181]

I am going to powder coat once I'm sure any mods are done to the frame. The few that I recall are

Seat mounting
Shifter mounting locations

What else everyone?

[Jaime]

Tabs to hold brake line ends.
Fuel filter bracket.

[JeromeS13]

Seatbelt anchor points if you ever intend to run a 5/6 point harness.

[Jaime]

You also might want to consider welding some nuts into the frame to make the body panels bolt-on. Rivnuts are OK, but they don't sit quite flush. On the other hand, these thing hold way better than you would expect:

29088

[AZPete]

A few electrical grounds?

[apexanimal]

http://m.imgur.com/a/ASBPB

[DodgyTim]

R or S? SixStar did some suspension mount gussets for the R that look sensible

[billjr212]

Have you looked into a simple hitch/bumper like what some of the hot rod guys are doing? Just throwing it out there.

[nkw8181]

wow nice input keep it coming!! mine is an S for street use with a track day here and there

[Mechie3]

You also might want to consider welding some nuts into the frame to make the body panels bolt-on. Rivnuts are OK, but they don't sit quite flush. On the other hand, these thing hold way better than you would expect:

29088

I'm using some low profile 10-32 rivnuts. Still not perfectly flush, but better than the standard height 1/4-20 rivnuts.

[Triathletedave]

Seatbelt anchor points if you ever intend to run a 5/6 point harness.

If you have an 818S, you may need to have seat belt anchor tabs welded in anyway. So far only the R frame set even has any anchoring tabs on it.