ignition switch

[ksamson]

I have the FF ignition switch. I am looking for alternatives instead of having so many wires connected to the starter switch.

[Gumball]

I used a reproduction '65 Mustang switch, but it has four wires connected to it - one for accessory power, one for run power, one for start signal, and one for the charging circuit.

This is what it looks like installed. It also has a cool old-style "FORD" ignition key.

http://i845.photobucket.com/albums/ab15/CCRsAC/IMG_20140511_140946923_zps99ca7027.jpg (http://s845.photobucket.com/user/CCRsAC/media/IMG_20140511_140946923_zps99ca7027.jpg.html)

[Bob Cowan]

Run the accessory wires to multiple relays, and then use the ignition switch to trigger the relays. Then you would only need 3 small wires and only 1-2 amps.

[skullandbones]

I can't see how you would be able to simplify it (FFR switch is 4 post) except maybe to use one wire off the power post to a terminal plate for other wires. I added a push button starter switch from Finish Line which helped. I think the stiffer signal wire in the harness was difficult to fit on the starter switch but easier to install on the remote switch. Trying to route a bunch of heavy gauge wires to one small area like that does create sort of a problem. Good luck,

WEK.