OK, Next problem - Throttle Cable

[palomino]

I installed the throttle pedal today then went to put in the cable but the little lead ball at the end of the cable falls right through the hole in the pedal arm. I called FF and they said it should fit without anything but the CAD picture shows some sort of spacer/washer.
What am I missing?????/

[Wayne Presley]

There should be a plastic sleeve on the cable to snap into the throttle pedal.

http://i213.photobucket.com/albums/cc175/vcpinjectionpb/818-build%201/P1020783_zps1d2bfeba.jpg (http://s213.photobucket.com/user/vcpinjectionpb/media/818-build%201/P1020783_zps1d2bfeba.jpg.html)

[palomino]

There was no plastic sleeve that I found.
I will have to call FF

[Bob_n_Cincy]

There was no plastic sleeve that I found.
I will have to call FF
I think the plastic sleeve is off the donor. see picture below:
28833

[RM1SepEx]

nope, comes on the new cable, too big to go through the hole, you have to drill extra large hole in firewall and use some sort of washer setup on firewall. I've seen updated instruuctions come through on one of the manual updates, I had to modify my own last summer when I did mine

[longislandwrx]

agreed, should be already installed on the cable, no way to install it after. chances are it cracked off during packing/transport.