bolting on aftermarker fuel rails

[RF RIDER]

Could someone with aftermarket fuel rails take a picture of how it is bolted down. I find the brackets are not quite at the right angle and I am not sure if I need a washer to hold plastic part of intake cover. Also if I am to reuse the intake bolts to secure rails. 4 bolt studs.
I did not have any instructions with my rails. Didn't receive original box with them.
Any help would be greatly appreciated.

[LCD Gauges]

Dave, I sent an email a couple of days ago in response to yours but it appears Yahoo/Rogers has some issues with their server and delayed transmissions.

There are no instructions with photos, or anything of that nature. It's just a bunch of text on the insert card as you see in these pictures.

Snap a photo of the brackets while they are installed on the manifold, and send it to my email, or post here.

I hope to have my rails installed tonight so I'll let you know if I have similar problems.
2792627927

[LCD Gauges]

Some pics of the rails partially installed. Please excuse the dust, and mess in the engine bay!

2794627947
No interference with the valve cover, or intake bolting bosses. The brackets are extended to the maximum;
I believe the LS2/LS3 brackets are not slotted like the LS1 brackets.
2794827949