View Full Version : Straight Axle Rear End
smithbks
04-09-2014, 09:47 AM
I'm preparing for my upcoming build in June and one of the issues I'm having the most trouble with is the rear end. I ordered the Complete kit but FFR can't ship rear ends from the vendor (looks like they discontinued the part) so I have to find my own. I don't mind rebuilding a used one but prefer to buy at least the housing already restored. My question is how much trouble is it to use a non 76-93 Ford 8.8? For example, there are quite a few good 2004 8.8 31 spline rear ends out there but I understand they are 3 inches or so wider. What mods have to be made to fit that and would it just look bad with the 10.5" rear wheels?
Other info on the build:
-351w engine from Engine Factory (427 with 535HP)
-TKO 600
Thanks guys!
Contact Mike. www.fortesparts.com
Olli
smithbks
04-09-2014, 10:59 AM
Thanks - I called and he is going to give me a quote. Could have saved myself hours of searching!
68GT500MAN
04-09-2014, 11:07 AM
Mike is a great resource for these type of questions.
Doug
DaleG
04-09-2014, 11:14 AM
If by chance you are going to install ABS, Mike can tweek the rear end with sensor brackets.
NukeMMC
04-09-2014, 12:17 PM
The Mustang 8.8" rear end housing (axle tubes and center section) 87-04 are all the same width, 59 1/4". The axles end up being different lengths. The Fox (87-93) width axles are 29 1/4" but are 4 lug, the 94-98 SN95 axles are 30" long and the 99-04 SN95 axles are 30 3/4". The FFR Roadster is best built with Fox length axles with a 5-lug flange and some sort of 3/4" reverse offset caliper mounting bracket for the SN95 rear brakes or use aftermarket (Wilwoods).
smithbks
04-10-2014, 06:54 AM
Good to know. I was worried the housing was different and would cause problems with both width and driveshaft. If it is only the axles that I have to worry about it gives me more options
Pylons
04-10-2014, 09:37 AM
I'm preparing for my upcoming build in June and one of the issues I'm having the most trouble with is the rear end. I ordered the Complete kit but FFR can't ship rear ends from the vendor (looks like they discontinued the part) so I have to find my own.
It's not discontinued, but they have temporarily stopped taking orders for the rear ends. The vendor has been having trouble sourcing the housings and was falling behind in production, so FF stopped taking orders to let them catch up.
Apparently I got one of the last orders through before the halt.
christenfreedman
04-15-2014, 11:15 PM
Call Mike...he is Great!