Rear end alignment with 3-link

[rcotner]

I have the panhard bar clevis' screwed in to a single thread on both ends so the bar is probably within 1/8" or so of its shortest possible setting. Even at this shortest panhard bar lenght the drive shaft flange on the rear end appears to be 1/4" to 1/2" shifted to the right. Has anyone encountered that before? I assume the U-joints on the drive shaft will absorb the offset but it is a bit disconcerting to see the rear end a bit off center. Thanks!

[michael everson]

The panhard bar centers the wheels left to right in relation to the body. Don't worry about it until the body is mounted.
Mike

[rcotner]

OK, thanks for the info!

[Mark Dougherty]

the pinion is not in the center of the rear
as mike says center the rear after the body is on