PDA

View Full Version : Adding bend in Roll Bar


CRZN 427
03-31-2011, 02:26 AM
I had to add some bend in the roll bar, this is the set-up I used to accomplish that.

I wanted to move the ene of each leg in 1 inch;, I actually had to bend the legs a little over 2 inches; to overcome the cold spring and have the correct measurement.

Regards, Rick.

http://www.ffcars.com/photopost/data/500/medium/Young_632.JPG
Pierre B
03-31-2011, 06:31 PM
Cleverly done with simple tools and materials. The trick has to be to keep the assembly flat on the board. Nice work.
CRZN 427
04-01-2011, 12:49 AM
Cleverly done with simple tools and materials. The trick has to be to keep the assembly flat on the board. Nice work.

Thanks for the acolade, but once you get the feel for the equipment...

http://i96.photobucket.com/albums/l189/crzn427/Young633.jpg?t=1301636681

Regards, Rick.