Turn Signal Stalk/Headlight Switch

[sonex772]

Hey All

I am getting ready to do the wiring and was going through the connector for the Turn Signal Stalk/Headlight Switch and found out that I was missing 4 wires and pins that go into the connector.
Does any one know where I can get the pins that go into those connectors?? It is the connector that is on page 316 of the manual.

Thanks
Mike2631626315

[VRaptor SpeedWorks, LLC]

I'm guessing that the pins that are missing were never there in the first place? That connector is never completely full....there are always empty spots in that connector. If you're actually missing pins that you need, just figure out which ones you don't need and transfer un-used pins to those locations......making sure you have proper wire gauge attached to those circuits.