Visit our community sponsor

Photo 15 of 84 from #007 Photo Album

Upper Arm and Ball Joint Replacement - We cut down the existing collar a bit and will be welding on a new one. Since the two ball joints install differently (screwed in vs press fit) and the height to the shoulder is a bit different the new collar will make up the difference keeping the upper and lower arms at the same separation.

Photo Added: 04-09-2014, 08:50 AM
Album: #007 Photo Album
Added by: Tom Veale

Visit our community sponsor

All times are GMT -5. The time now is 01:45 PM.

The representations expressed are the representations and opinions of the TheFactoryFiveForum.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Factory Five Racing, Inc. or Ford Motor Company.
This website has been planned and developed by TheFactoryFiveForum.com and its forum members and should not be construed as being endorsed by Factory Five Racing, Inc. or Ford Motor Company for any purpose.
"FFR", "Factory Five", "Factory Five Racing", and the Factory Five Racing logo are registered trademarks of Factory Five Racing, Inc.
TheFactoryFiveForum.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s).
Thank you for visiting the TheFactoryFiveForum.com.
Copyright 2011 Factory Five Racing, Inc. All rights reserved.
COBRA is a registered trademark of the Ford Motor Company. The Factory Five Forum is not connected to the holders of this mark.
The Factory Five Forum is not connected in any way to Carroll Shelby.